Volvo L220H Wheel Loader
Category: Wheel Loaders (See all Wheel Loaders for sale)
Manufacturer: Volvo (See all Volvo Equipment for sale)
Model: L220H (See all Volvo L220H for sale)
Axles
| Axle oil front | 20 gal (77 l) |
| Axle oil rear | 19 gal (71 l) |
| Front | Volvo AWB 50 |
| Rear | Volvo AWB 41 |
| Rear Axle Oscillation | 15 degrees |
Bucket
| Breakout Force | 54,134 lbs (24,555 kg) |
| Dump Clearance at Max Raise | 10 ft (3 m) |
Dimensions
| Ground Clearance | 2 ft (1 m) |
| Height - Top of Cab | 12 ft (4 m) |
| Hinge Pin - Max Height | 15 ft (5 m) |
| Length with Bucket on Ground | 31 ft (9 m) |
| Reach at Max Lift and Dump | 5 ft (2 m) |
| Wheelbase | 12 ft (4 m) |
| Width Over Tires | 10 ft (3 m) |
Drive System
| Torque multiplication, stall ratio | 2.02:1 |
| Auto-Shift Transmission | Volvo HTL 310 |
| Transport speed, maximum | 23 mph (37 kph) |
Electrical System
| Alternator rating | 2280/80 (W/A) |
| Battery Capacity | 2 x 170 Ah |
| Cold cranking capacity | 1000 A |
| Starter motor output | 9 hp (7 kw) |
| Voltage | 24 V |
Engine
| Aspiration | Turbocharged |
| Displacement | 781 cu in (12,802 cu cm) |
| Engine Model | Volvo D13J |
| Gross Power | 368 hp (274 kw) |
| Make | Volvo |
| Model | D13J |
| Net Power | 366 hp (273 kw) |
| Number of Cylinders | 6 |
| Power Measured @ | 1400 rpm |
| Torque Measured @ | 1100 rpm |
Hydraulic cycle times (unloaded)
| Lift | 6.8 seconds |
| Lower | 3.2 seconds |
| Tilt | 1.6 seconds |
| Total cycle time | 11.6 seconds |
Hydraulic System
| Engine speed | 1900 rpm |
| Working pressure | Pump 1 - 29 MPa, Pump 2 - 31 MPa, Pump 3 - 25 MPa |
Operating Specifications
| Cooling System Fluid Capacity | 15 gal (55 l) |
| DEF tank capacity | 8 gal (31 l) |
| Engine Oil Fluid Capacity | 13 gal (50 l) |
| Fuel Capacity | 97 gal (366 l) |
| Hydraulic System Fluid Capacity | 60 gal (226 l) |
| Operating Weight | 70,967 lbs (32,190 kg) |
| Rated Bucket Capacity | 5-21 cu yd (4-16 cu m) |
| Transmission Fluid Capacity | 13 gal (48 l) |
Steering System
| Articulation angle | 37 degrees |
| Cylinder bore | 4 in (10 cm) |
| Maximum flow | 53 gpm (202 lpm) |
| Rod Diameter | 2 in (6 cm) |
| Steering cylinders | 2 |
| Stroke | 2 ft (1 m) |
| Working pressure | 21 MPa, 210 bar |
Weights
| Operational Weight | 62,000-71,000 lbs (28,123-32,205 kg) |
